If in case your bathtub faucet is dripping or leaking for some time then it is time to replace bathtub faucets. Simple as it may sound there’re a couple of factors you should look in to while replacing it. Follow the tips presented here and replacing bathtub faucets will be a fairly easy task. Faucets [...]
If in case your bathtub faucet is dripping or leaking for some time then it is time to replace bathtub faucets.
Simple as it may sound there’re a couple of factors you should look in to while replacing it.
Follow the tips presented here and replacing bathtub faucets will be a fairly easy task.
Faucets allow water flowing in pipes to be used in controlled manner. Usually most bathtubs have either two valve or 3 valve faucets.
Faucets generally start dripping or leaking when their washers become corroded and stiff. Water pressure acts to hasten this process. In most earlier design faucets there were neoprene or rubber washers. In the newer systems a cartridge is used instead of washers.
It’s almost always necessary to buy a correct faucet. Faucets come in lots of styles and sizes. When you have to change a faucet it’s essential to take exact measurement of holes centre to centre. While style is optional but size is not.
And you should have the right tools to replace a faucet. There are many types of wrenches for plumbing jobs.
For square or hex nuts open end wrenches are ideally suited as these have smooth jaws. If your pipe is chrome coated and you do not want to damage the surface then you can go for a strap wrench. If the pipe is of small diameter then you should have a vise grip wrench.
Typically 2 pipe wrenches are required for plumbing tasks. One to hold and the other to turn.
While installing a bathtub faucet opt for the faucet assembly behind the walls. Typically builders would have provided a rear access panel in the rear of the tub. Do take a look the installation instructions when assembling the two valve or 3 valve water faucets.
And listed below are some typical steps to change a dripping water faucet.
• First, turn the water supply off. You could turn off the main water supply for the entire house.
• Next remove the faucet handle. Tap or pull softly. Over time the handle might have gotten welded to the stem. So do not force it. If it doesn’t come out easily then use a special handle puller.
• Next remove the stem and the trim assembly. This assembly is needed to control the amount and temperature of water output to the tub. Utilize a bath socket wrench to remove this assembly.
• Then check the washer itself. Incase it is torn or brittle then this is the cause for the leak. Replace the stem and the washer.
• Check the seats. If the seats are rough then they too must be replaced. Use a seat wrench to remove it.
• While changing the various components you should just assemble it all back together. Apply grease to the washer, stem threads and nut threads. Afterward slide them all back and fasten the nuts.
• If it’s a cartridge style faucet then take out the trim and handle. Then change the cartridge.
So with a just a little bit of knowledge you might fix it yourself for $80-$90.
In the same vein, it’s easy to fix a leaky shower faucet also.
Content © vipwealth.net
Proudly powered by WordPress
Theme designed by Artisan Themes
38 queries.
0.413 seconds.